Tips When Using Once Fired Brass With A Firearm

Once fired brass has a lot of advantages over new ammunition, especially in the cost department. If you're going to be using it with your firearms, knowing about this protocol can help you enjoy these used casings a lot more.

Find Out How Many Times Brass Has Been Fired

The condition of once fired brass casings matters tremendously in how you're able to use them with your own weapon. Once you find a supplier offering once fired brass, ask them directly how many times the brass has been fired. It may have been just once, a couple of times, or more than a dozen.

The more times the brass has been fired, the more problems there could be with it. For instance, there could be structural issues that are hard to address when you go to set bullets in place. If you find out the firing quantity, you'll make a much better selection.

Verify Brass Has a Reloadable Design 

You want to remember that not all once fired brass is reloadable. Sometimes, a single fire can structurally damage the brass casings to the point where reloading is no longer feasible. When you start looking for once fired brass from suppliers, it helps to verify that all of their brass inventory has a reloadable design.

Then you won't have to question what type of performance you're getting once your brass casings arrive. And if there is an issue even when the supplier verified the reloadable design, you can easily get your money back or have the supplier send out once fired brass that is free of defects.

Make Sure Once Fired Brass Is Cleaned Thoroughly

In order for you to use once fired brass effectively with your firearms, it's imperative that the brass casings are thoroughly cleaned before being shipped off. Then you'll have a much easier time setting bullets and keeping them in place.

Whereas if the once fired brass wasn't properly cleaned by the company you order from, dirt and debris could interfere with bullet setting and cause you to work a lot harder. Dirty casings could even lead to corrosion and then render once fired brass useless.

A lot of gun enthusiasts opt to use once fired brass for casings because they're readily available and inexpensive. If you're using these casings as well, it comes with a little more responsibility from a shopping standpoint. If you analyze the right things though, making the right selection and using once fired brass appropriately are easily achievable. 

For more information, contact a once fired brass supplier.